兼容genie遥控器的说明.docVIP

兼容Genie遥控器的说明 一、 Genie原遥控和兼容遥控器的介绍 RS286 Double frequency: 315/390MHz Press the remote control button when the two frequency turns 二、Compatible Genie remote controller and reveiver 一）、Three are two kinds of receiver of Genie remote controller, Picture 5(Genie reveiver A) and Picture 6 (Genie reveiver A) Picture 5 enie reveiver A Picture 6 enie reveiver B 注： 1、Pictre 5：the frequency of it is390MHZ，LED is double LED light，After power on Green Lantern Festival has been in slow flicker, the red light is for learning remote control and remote control status indication normal to extinguish state. 2、 Picture 6：the frequqncy of it are 390MHZ and 315MHZ，LED is single LED light，For remote control learning and remote control of the status of the instructions, the normal state of extinction; 3、Two receiving box access power supply: DC 12V-24V； 二）、Learning remote control code steps: 1, press the control box on the learning button and then released, the receiving box on the red LED will flash 2 times per second; 2, in 30 seconds to press the remote control to learn the button, then the receiver box on the red LED president; 3, in 30 seconds again press the remote control with a key to learn, receiving box of red LED will burn out, then the end of the study; 三）、Receiver box control status By pressing the remote control button that has been learned, the red will flash when the president of the red LED is about 1S. When the remote control button is pressed, the red LED will always blink when there is no study or learning; 四）、Delete the control box has been recorded by the remote control Press the button until the receiving box learning receiver box red D exterminate, successfully deleted; Note: each remote control: there is only one button can control receiving box, namely if you learn all of the keys of the remote controller to receive inside the box, it will only last effective learning remote control button and receiving box