HT53 交换机和路由器 实验.docVIP

要求所有计算机、交换机、路由器的接口相互联通。 1. 交换机下的计算机在两个网络段，要求划分vlan，要求switchA 和switchB 的f0/5 和f0/6 在vlan 2； routerA: Routeren Router#config t Enter configuration commands, one per line. End with CNTL/Z. Router(config)#int f0/0 Router(config-if)#ip add 10.65.1.2 255.255.0.0 Router(config-if)#no shut %LINK-5-CHANGED: Interface FastEthernet0/0, changed state to up Router(config-if)#int s0/1 Router(config-if)#ip add 10.68.1.2 255.255.0.0 Router(config-if)#no shut %LINK-5-CHANGED: Interface Serial0/1, changed state to down Router(config-if)#int f0/1.1 Router(config-subif)#en Router(config-subif)#encapsulation d Router(config-subif)#encapsulation dot1Q 1 Router(config-subif)#ip add 10.66.1.4 255.255.0.0 Router(config-subif)#int f0/1.2 Router(config-subif)#en Router(config-subif)#encapsulation d Router(config-subif)#encapsulation dot1Q 2 Router(config-subif)#ip add 10.60.1.4 255.255.0.0 Router(config-subif)#int f0/1 Router(config-if)#no shut %LINK-5-CHANGED: Interface FastEthernet0/1, changed state to up %LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/1, changed state to up %LINK-5-CHANGED: Interface FastEthernet0/1.1, changed state to up %LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/1.1, changed state to up %LINK-5-CHANGED: Interface FastEthernet0/1.2, changed state to up %LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/1.2, changed state to up Router(config-if)#end %SYS-5-CONFIG_I: Configured from console by console Router#show run Building configuration... Current configuration : 940 bytes ! version 12.2 no service timestamps log datetime msec no service timestamps debug datetime msec no service password-encryption ! hostname Router ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! interface FastEthernet0/0 ip address 10.65.1.2 255.255.0.0 duplex auto speed auto ! interface FastEthernet0/1 no ip address duplex auto speed auto ! interface FastEthernet0/1.1 encapsulation dot1Q 1 native ip address 10.66.1.4 255.255.0.0 ! interface FastEthernet0/1.2