InstructionsforTurningGear.docVIP

Instructions for 135 Turning Gear Rotary equipment This equipment applies adjustable variable frequency rotary equipment, and the rotary speed is set at 3~62.5rpm. The initial set rotary speed is 7~8rpm. The purpose is to prevent idling speed cannot be maintained a lower value for the reasons of system or operation. According to the practice in power plant, the proper initial set value shall be at 7~8rpm. It has P.LTG-135 model variable frequency speed regulating automatic control cabinet; P.RAC-135DCF-8 model pneumatic control solenoid control cabinet; P.LTG-135 model low speed rotary operation engagement device; P.LTG-135 model pneumatic control shunting oil injection valve, pneumatic control connecting pipeline and control circuit. The main functions of rotary control devices: The instructions on operation functions keyboards on variable frequency speed regulating self-control cabinet: Tracing gear---Emergency shutdown function: When trace DCS 0 revolution signal, the control device begins to “start up” automatic turning gear system; when revolution reaches 7~8rpm, put automatic low speed turning gear into operation. Quasi-automation gear-semi-automation turning gear function: primary button “start” to put semi-automatic turning gear (the condition is that revolution reaches “0”); for shutdown, do not use that gear; Inching gear-used for maintenance. When correct turbine and generator, can inch “start” button to turn rotor for certain degree of angle. Manual gear-Air failure status function, when air source fails and impossible to implement automatic turning gear, reset to original 62.5r/min turning gear conditions, can adopt manual pulling-pin and manual engagement to put turning gear into operation; In addition, adjustable variable frequency low speed rotary control device also has following functions: Automatic pneumatic control is used to open the oil circuit of lube oil system, lubricate the bearing seat by injecting oil. The work principle of system: Work