DigitalVideoCamcorder.PDFVIP

© 2002 Matsushita Electric Industrial Co., Ltd. All rights reserved. Unauthorized copying and distribution is a violation of law. NV-DS30EG NV-DS30EGM NV-DS30B NV-DS30EGE NV-DS30EN NV-DS30ENT NV-DS30ENC NV-DS30A VOL.2 Digital Video Camcorder ORDER NO. VMD0202008C8 1 SERVICE NOTES (PLEASE READ) 3 1.1. SERVICE NOTES 3 2 SCHEMATIC DIAGRAMS 5 2.1. SCHEMATIC DIAGRAM CIRCUIT BOARD LAYOUT NOTES 5 2.2. MAIN SCHEMATIC DIAGRAMS 6 2.3. VOLTAGE CHART 21 3 CIRCUIT BOARD LAYOUT 23 3.1. MAIN C.B.A. 23 4 BLOCK DIAGRAMS 25 5 REPLACEMENT PARTS LISTS 35 5.1. REPLACEMENT NOTES 35 5.2. ELECTRICAL REPLACEMENT PARTS LIST 36 CONTENTS Page Page 2 NV-DS30EG / NV-DS30EGM / NV-DS30B / NV-DS30EGE / NV-DS30EN / NV-DS30ENT / NV-DS30ENC / NV-DS30A 1 SERVICE NOTES (PLEASE READ) 1.1. SERVICE NOTES 1.1.1. EXTENSION CABLES FOR SERVICE POSITION Using the following Extension Cables, place the unit as shown for check and service. Extension Cables (No.5 ~ No.8) are used for improving serviceability. (They are not necessarily used.) Note : 1. The LCD open/close SW. is for changing between LCD Display or EVF Display. When turning on LCD Display, place some paper or tape, etc. on LCD open/close SW. so that this SW. stays ON. 2. Connect the F.P.C.s to the connectors, verifying the direction of F.P.C. as shown. 3. Use a grounded ESD wrist strap while disassembling the Lens portion. 4. Use extreme care when unplugging or plugging in connectors. 3 NV-DS30EG / NV-DS30EGM / NV-DS30B / NV-DS30EGE / NV-DS30EN / NV-DS30ENT / NV-DS30ENC / NV-DS30A Fig. 1 4 NV-DS30EG / NV-DS30EGM / NV-DS30B / NV-DS30EGE / NV-DS30EN / NV-DS30ENT / NV-DS30ENC / NV-DS30A 2 SCHEMATIC DIAGRAMS 2.1. SCHEMATIC DIAGRAM CIRCUIT BOARD LAYOUT NOTES 1. Important safety notice Components identified by the sign have special characteristics important for safety. When replacing any of these components. Use only the specified parts. 2. Do not use the part number shown on this drawing for ordering. The correct part number and part va