CLAMPSENSOR.PDFVIP

CLAMP SENSOR Wide-band Models from DC to 100 MHz 3276 CLAMP ON PROBE http://www.hioki.co.jp/ HIOKI company overview, new products, environmental considerations and other information are available on our website. 1 3273-50 to 3276 CLAMP ON PROBE Because current measurement requires the insertion of a shunt or a CT, the task often becomes difficult due to breaks in the electrical path. The 3273-50 - 3276 CLAMP ON PROBEs only need to be connected directly into the BNC input on waveform observation equipment such as an oscilloscope or a recorder. Then simply clamp onto the conductor to be measured to easily observe current waveforms under a wide bandwidth and high sensitivity conditions. Important Characteristics 3273-50 DC to 50 MHz 3273-50 ■ Square wave response ■ Transient response ■ Low-current measurement Input: 1 kHz square wave 200 mAp-p Input: 1 MHz square wave 200 mAp-p Input: 100 mAp-p Input: 1 kHz sine wave 10 mAp-p (Oscilloscope bandwidth 400 MHz) (Oscilloscope bandwidth 400 MHz) (Oscilloscope bandwidth 400 MHz) (Oscilloscope bandwidth 20 MHz) ■ 1. Frequency response ■ 2. Continuous maximum input ■ 3. Input impedance (Characteris