STM32时钟配置函数.pdf

STM32F103 单片机 SystemInit() 函数介绍 备注：此文档为个人实际操作经验，鄙人非大神，如有错误还请指教，谢谢 1 原库函数 注：黑色字体为函数代码，紫色的为注释，红色的是我的理解。 cl：互联型产品，stm32f105/107 系列 vl：超值型产品，stm32f100 系列 xl：超高密度产品，stm32f101/103 系列 ld：低密度产品，FLASH 小于 64K md：中等密度产品，FLASH=64 or 128 hd：高密度产品，FLASH 大于 128 void SystemInit (void) { /* Reset the RCC clock configuration to the default reset state(for debug purpose) */ /* Set HSION bit */ RCC-CR |= (uint32_t)0 /* Reset SW, HPRE, PPRE1, PPRE2, ADCPRE and MCO bits */ #ifndef STM32F10X_CL RCC-CFGR = (uint32_t)0xF8FF0000; #else RCC-CFGR = (uint32_t)0xF0FF0000; #endif /* STM32F10X_CL */ /* Reset HSEON, CSSON and PLLON bits */ RCC-CR = (uint32_t)0xFEF6FFFF; /* Reset HSEBYP bit */ RCC-CR = (uint32_t)0xFFFBFFFF; /* Reset PLLSRC, PLLXTPRE, PLLMUL and USBPRE/OTGFSPRE bits */ RCC-CFGR = (uint32_t)0xFF80FFFF; #ifdef STM32F10X_CL /* Reset PLL2ON and PLL3ON bits */ RCC-CR = (uint32_t)0xEBFFFFFF; /* Disable all interrupts and clear pending bits */ RCC-CIR = 0x00FF0000; /* Reset CFGR2 register */ RCC-CFGR2 = 0 #elif defined (STM32F10X_LD_VL) || defined (STM32F10X_MD_VL) || (defined STM32F10X_HD_VL) /* Disable all interrupts and clear pending bits */ RCC-CIR = 0x009F0000; /* Reset CFGR2 register */ RCC-CFGR2 = 0 #else /* Disable all interrupts and clear pending bits */ RCC-CIR = 0x009F0000; #endif /* STM32F10X_CL */ #if defined (STM32F10X_HD) || (defined STM32F10X_XL) || (defined STM32F10X_HD_VL) #ifdef DATA_IN_ExtSRAM SystemInit_ExtMemCtl(); #endif /* DATA_IN_ExtSRAM */ #endif /* Configure the System clock frequency, HCLK, PCLK2 and PCLK1 prescalers */ /* Configure the Flash Latency cycles and enable prefetch buffer */ SetSysClock(); #ifdef VECT_TAB_SRAM SCB-VTOR = SRAM_BASE | VECT_TAB_OFFSET; /* Vector Table Relocation in Inte