造纸废水处理系统的初步论文.docVIP

 PAGE \* MERGEFORMAT 21 (此文档为word格式，下载后您可任意编辑修改！) 造纸废水处理系统的初步设计 黄莹 (陕西理工学院化学学院环工专业1101班，陕西 汉中 723000) 指导教师：刘智峰 [摘要] 本设计的内容为某造纸厂废水处理工艺设计。设计处理能力为5000m3d，设计进水水质为：BOD5≤ 1200mgL，COD≤1800mgL，SS≤2000mgL。通过对多种造纸污水处理工艺比较及针对造纸废水的基本特点，最终选用的处理工艺:筛网过滤—物化处理—生化法处理。污水处理厂的出水水质要求达到《造纸工业水污染物排放标准》（GB3544-2001）中一般机制纸、纸板造纸工艺的标准。本设计所采用的工艺主体为生物接触氧化池，该工艺不仅能够有效地去除水中的BOD5，还具有良好的脱氮除磷功能。 [关键词] 造纸工业废水；水解酸化；污泥浓缩；生物接触氧化池 The Primary Design of Paper Making Wastewater Treatment System HuangYing Grade11,Class1,Major Environmental engineering?,School of Chemical and Environmental Sciences,Shaanxi University of Technology,Hanzhong 723000,Shaanxi） Tutor: Liu Zhifeng Abstract： This is paper marking waste water treatment process design. The design capacity of 5000m3d, the effluent quality is: BOD5 ≤ 1200mgL, COD ≤ 2800mgL, SS ≤ 2000mgL.Through looking up comparing with a variety of paper marking waste water treatment technology, according to the basic characteristics of the paper marking waste water, the specific programs I is like this: sieve net filter, physico-chemical treatment, biochemical treatment.Sewage treatment plant effluent quality meet the standards for paper industrial water pollutant discharge standard (GB3544-2001) general machine-made paper and paperboard paper making process requirements.The main technology used in this design is biological contact oxidation tank, which can not only remove the BOD5 effectively, but also of nitrogen and phosphorus removal. Key?words:?paper?mill?waste water; acid 目 录 TOC \o 1-3 \h \u 摘要  PAGEREF _Toc27038 1 关键词  PAGEREF _Toc22405 1 Abstract  PAGEREF _Toc15928 2 Key?words  PAGEREF _Toc22425 2 引言  PAGEREF _Toc18171 6 1?造纸废水的来源及特点  PAGEREF _Toc6767 6 1.1 造纸废水的来源  PAGEREF _Toc32437 6 1.2造纸废水特点  PAGEREF _Toc9205 6 2?设计说明书  PAGEREF _Toc7202 7 2.1设计依据  PAGEREF _Toc12422 7 2.2设计原则  PAGEREF _Toc3156 7 2.3设计内容  PAGEREF _Toc25006 7 2.4 造纸废水处理基本工艺  PAGEREF _Toc19522 7 2.4.1 物理处理方法  PAGEREF _Toc7631 7 2.