Detection of rock strength at Branisko massif.docVIP

Acta Montanistica Slovaca Ro?ník 5 (2000), 3, 233-236 Detekcia pevnosti horninového masívu Branisko Edita Lazarová 1 Detection of rock strength at Branisko massif When monitoring and optimizing the driving proces of the exploratory gallery by a computer system, conditions for verification of the interaction between desintegrating head of driving machine and rock massif were created. One of the output values of this mathematical model is the model strength at a simple pressure σ , which is defined as a pressure at the discus and the massif contact during the tlH desintigration (a near limit of massif strength). By geological and geological engineering exploration, the section of length 2340 m was divided into fourty-two geological sections and five quasi-homogeneous massif enviroments. In the article, results of scleroscopic strength σ the strength in a simple pressure determined from the point load test and the strength at simple pressure σ are confronted . The main tlH CI , advance of the electronic geomechanical monitoring is the density of gained information. The two-seconds sample period of input and output data during the driving process makes it possible to describe driving circumstances in an almost continual way for each millimeter of the built tunnel. Then the information about changes of disintegrated rock properties, have the same density (frequency). By comparing a quantity of data gained by examining the index of point strength, scleroscopic strength and the model strength in a simple pressure from the monitoring process of driving process it is obvious that during the driving of exploratory gallery of motorway tunnel Branisko, a proportion of data number from the three “type examinations” of strength was reached and it was approximately 1:7:5000. Approximately in the same proportion, there were determined values for the 42 geologic sections (I. – XLII.), which were defined in detai