ABBi-busKNXEnergyActuatorSES3.16.1ProductInformation.pdfVIP

® ABB i-bus KNX Energy Actuator SE/S 3.16.1 Product Information ® ABB i-bus KNX Energy Actuator SE/S 3.16.1 ® The new ABB i-bus KNX Energy Ac- operating period or when a defined tuator SE/S 3.16.1 is a Switch Actua- consumption threshold is reached. tor that records the energy consump- Additionally, when a stop event occurs, tion of the connected electrical loads the assigned output can be switched off. in the building. For each channel, the active power, cur- With the intelligent power grids of to- rent and voltage as well as further elec- morrow – the Smart Grids – the electri- trical variables (apparent power, crest cal building installations will be facing factor, power factor and frequency) can new challenges. In order to increase the be measured. The measured values are energy efficiency of buildings and at the made available via the KNX. They can same time integrate the consumers in be monitored with threshold values . the load compensation, it is necessary Should an overshoot or undershoot of a to switch electrical devices in buildings defined threshold occur, a warning can on and off based on external signals be sent or a channel switched. such as time, consumption thresholds or similar. The ETS application also enables a The ABB i-bus® KNX provides the simple load management functionality, Application optimum prerequisites for intelligent where up to ten Energy Actuators can Active consumption measurement buildings. be interconnected. The electrical loads Monitoring of electrical values