论文题目︰浅析滚动轴承的加工工艺.docVIP

论文题目：浅析滚动轴承的加工工艺 专业班级：G02××班 作者姓名：××× 指导教师：××× 完成日期：2005.5.26 （浅析滚动轴承的加工工艺） 姓名：××× 系别：×××××系 专业：××××× 研究方向：滚动轴承的加工工艺 指导老师：××× 论文完成日期：2005.5.26 摘 要 本论文围绕着滚动轴承加工工艺，结合自己在××轴承有限公司实习中所学到的一些工作经验，并参阅有关的资料，简述了滚动轴承的基础知识，探讨了滚动轴承从进厂到出厂的各道工序和工艺，分析了滚动轴承的加工过程和工序流程，论述了防锈的重要性和有效的防锈的措施，并就脂润滑和油润滑作了分析，最后列举了轴承的损伤与其相应的对策。 关键词 滚动轴承，工艺，质检，装配 Abstract This thesis is around the topic of researching the craft of the process of the roll over bearings. I have practiced in the TianAn limited company for two months. In the thesis, I wrote what I have learnt, what I have seen in the practice, and some my own experience with the work. At the same time, I read a lot of relevant data about the roll over bearings and learnt a lot from it. The thesis researched the working preface and the craft of the roll over bearings between the bearings putting into and outing of the factory, introduced some foundation knowledge about the roll over bearings, analyzed the process and the work preface of the process of the roll over bearings, discussed the importance of defending the rust and the valid measure of defending the rust, brief introduced the effect of the lubricate and compared the difference between the oil lubricate and the grease lubricate. At the end, it enumerated the bearing’s hurt and the homologous Solution method 。 Key words Roll over bearings;Whet;Quality checking;Assemble;  目录 引言...............................................................1 1 滚动轴承的基础知识...............................................1 1.1滚动轴承的概述..................................................1 1.2滚动轴承的组成及各零件的作用....................................1 1.3 滚动轴承的分类.................................................2 1.4 滚动轴承的代号.................................................2 1.5 滚动轴承的精度.................................................3 2 滚动轴承的基本加工过程...........................................3 2.1主要零件的加工过程............................................. 3 2.2 滚动轴承的装配过程..