支持多点传输的能馈式牵引供电装置监控系统设计 .pdfVIP

学兔兔 总第48卷 第546期 电测与仪表 VO1．48 NO．546 2011年 第06期 ElectricaI Measurement Instrumentation Jun．201 1 支持多点传输的能馈式牵引供电装置监控系统设计 王娜娜，邱瑞昌，耍利娜 ，宋永丰，李泽荣 (北京交通大学电气工程学院，北京100044) 摘要：针对新型能馈式牵引供电装置采用PWM整流以及多模块并联的特点，本文设计监控系统，为迎合其监控 变量多、实时性要求强的特殊性。监控系统采用双DSP控制，以工业以太网为主要传输介质，同时与本地嵌入 式监控端和远程监控终端进行数据传输。对监控板硬件进行整体设计；在软件设计方面，提出一种新型的使用 UDP报文进行请求应答的握手连接机制，并在监控板的程序设计中提出新的思路，来迎合双上位机的需要；并 设计了Labview监控界面。最后通过实验验证了整个监控系统的稳定性和实时性，达到了预期的各项要求。 关键词：监控系统；DSP；工业以太网；UDP；Labview 中图分类号：TM933 文献标识码：B 文章编号：1001—1390(2011)06—0058—05 Design of Monitor System for Energy Feedback Traction Power Supply System Support Multi——point Transmission WANG Na—na，QIU Rui—chang，SHUA Li—na，SONG Yong—feng，LI Ze—rong (School of Electrical Engineering，Beijing Jiaotong University，Beijing 100044，China) Abstract：According to the characteristic of the new energy feedback traction power supply system using PWM rectifica— tion and multi—paralleled topology，this paper introduced a monitor system which is suitable for its many monitoring variables and its real—time request．The monitor system which contains dual—DSP controller communicates with both local embedded platform and a remote PC based on Ethernet．After the design of the monitor system’S hardware，it proposed a new communication design for request and response based on UDP to make sure the network connection is norma1．At the same time，this article designed a new software flowchart of DSP to meet the needs of the dual—PC， and it designed the Labview monitor interface as wel1．At last，the experimental results were shown，according to the practice，this monitor system had good features of stability and real—time，and it could reach the expected d