相序电压幅值比较的交直流电网故障选相.pdfVIP

第 25 卷第4 期 电力系统及其自动化学报 Vol.25 No .4 2013 年8 月 Proceedings of 由e CSU:-EPSA Aug. 2013 相/序电压幅值比较的交直流电网故障选相 陈静12 ，唐飞1 ，廖清芬1 (1.武汉大学电气工程学院，武汉 43∞72; 2.江苏省电力公司电力科学研究院，南京 211103) 摘要:为弥补传统选相元件在交直流混联电网逆变站侧交流出线短路故障时可能误判的缺陷，研究了基于 相/序电压分量幅值比较的新型选相方案。根据故障边界条件和序网结构，分析了不同短路类型下故障相、 非故障相电压与正序电压幅值的相对大小规律，通过简单的幅值比较即可快速筛选出故障相。该方案无需 辅助判据，且不受换流站非线性响应特性的影响。我国某实际电网的仿真验证了该算法的有效性。 关键词:交直流混联电网;故障选相;受端系统;换相失败:幅值比较 中图分类号: TM8 文献标志码:A 文章编号: 1∞3-8930(2013)04-∞，29-05 Faulty Phase Selection Criterion in ACIDC Hybrid Power System ßased on the Comparison of Phase/Sequence Voltage Amplitude 1 1 1 CHEN Jing 气 TANG Fei , UAO Qing-fen (1.School of Electrical Engineering , Wuhan University , Wuhan 43∞72 ， China; 2.Electric Power Research Institute , Jiangsu Electric Power Compang , Nanjing 211103 , China) A恼仕act: In order to tackle the deficiency that the conventional phase selection component may mal-operate when short-circuit fault ωcurs at AC ouÙet of inverter side in a AC/DC hybrid grid , .a novel faulty phase selection algorithm which is based on the comparison of phaselsequence voltage amplitude has been proposed in this paper. In 也is paper , on the basis of boundary conditions of contingency and the se甲lence network topology , the quantitative relationship of the faulty phase , non-fault phase voltage amplitudes and the positive sequence voltage amplitude have been analyzed. Hence the faulty phωe can be rapidly identified via simple amplitude comparison. 币lis algorithm is wi由out auxili町y criterion and is free of the non-linear characteristic of the convertor stations. The