Analysis of Tool Wear Rate in Drilling Operation using Scanning Electron Microscope (SEM)英文文献资料.docVIP

Journal of Minerals Materials Characterization Engineering, Vol. 11, No.1, pp.43-54, 2012 jmmce.org Printed in the USA. All rights reserved Analysis of Tool Wear Rate in Drilling Operation using Scanning Electron Microscope (SEM) Anil Jindal Department of Mechanical Engineering, GGS College of Modern Technology, Kharar (Punjab), India ABSTRACT Hole making had long been recognized as the most prominent machining process, requiring specialized techniques to achieve optimum cutting condition. Drilling can be described as a process where a multi-point tool is used to remove unwanted materials to produce a desired hole. It broadly covers those methods used for producing cylindrical holes in the work piece. However, high production machining and drilling with high cutting velocity, feed and depth of cut is inherently associated with generation of large amount of heat and high cutting temperature. Such high cutting temperature not only reduces dimensional accuracy and tool life but also impairs the surface integrity of the product. In this case, high pressure coolant (HPC) is very effective to reduce temperature. When temperature is increased a large amount of tool wear appears at the drill bit. In this situation, high temperature either affects roundness of the hole or chip shape and color of chip. HPC is applied in the same direction as the drill bit. HPC has reduced temperature as well as improving roundness and also provide lubrication in the tool tip and surface interface. Keywords: High-pressure coolant (HPC), drilling, chip, roundness, taper and tool wear. 1. INTRODUCTION The growing demand for higher productivity, product quality and overall economy in manufacturing by machining, grinding and drilling, particularly to meet the challenges thrown by liberalization and global cost competitiveness, insists high material removal rate and high stability and