基于变形技术的反求建模再设计.pdfVIP

2015年 10月 机 床 与 液 压 0 8 2015 第 43 卷第 19 期 M ACHINET 00 L 2 HYDRAULICS Vol. 43 No . 19 DOI : 10.3969/j . issn. 1001-3881. 2015. 19. 031 基于变形技术的反求建模再设计 李硕 , ,成思源 , ,杨雪荣2,2 ( 1.广东工 业大学机电工 程学院 ， 广东广州510006 2 . 广东省创新方法与决策管理系统重点实验室， 广东广州510006) 摘要：缩短产品设计周期，降低成本对于提高企业快速反映市场的能力必不可少。通过对不同变形技术的分析，提出 了将两种变形方法和反求建模相结合的職计方法，即首先将光学扫描后的点云数据导人到Geomagi s u d i 系统中进行修 复和曲面重构，然后将重构之后的模型导人到ThmkDesgn和Freeform中进行職计，最后将得到的STL模型用于3D 打印， 并以实际案例表述了整个过程。 关键词：变形技术；反求建模；修复；再设计 中图分类号：TH391.7 文献标志码： A 文章编号：1001-3881 (2015) 19-128-4 Reverse Modeling and Redesign Based on Deformation Techniques LI Shuo 1，2 CHENG Siyuan 1，2 YANG Xuerong 1，2 (1. School of Electromechanical Engineering ， Guangdong University of Technology ， Guangzhou Guangdong 510006, China); 2. Key Laboratory of Innovation Metliod and Decision Management System of Guangdong Province ， Guangzhou Guangdong 510006，China ) Abstra ct ： Shortening product design cycles and reducing the costs of products are essential to tion of thie marl^et of enterj)rises. Through the analysis of diferent deformation techniques， the redesign methiod of reverse modeling inte­ grated withi two deformation methiods was proposed. Firstly， the point cloud data obtained from optical scanning were introduced and processed in Geomagic studio system for fixing and reconstruction of curved surfaces， then the model obtained after reconstruction was introduced and redesigned in Thinkdesign and FreeForm. Finally the obtained STLmodel will be printing， and the practical case example expresses the entire process. Keywords ： Deformation