机组微油点火启动初期蒸汽温度的控制.pdfVIP

Vo l. 42 No.11 第 42 卷第11 期 热力发电 Nov.2013 2013 年 11 月 THERMAL POWER GENERATION 机细微池立九怠劫和勒笨?免程度i{:) ð，急剧 黄卫军，潘瑞强，於晓博，石宝全 江苏国华陈家港发电有限公司，江苏盐城 224631 [摘 要]基于对江苏国华陈家港发电有限公司(国华港电)超超临界 660 MW 机组微油点火 冷态启动过程中蒸汽温度偏高原因的分析，提出了在机组启动初期投入加热器的方 案，以提高给水温度，控制蒸汽温度，避免了机组并网后汽轮机因金属热应力过大而 难以升负荷的问题;通过在线监测和调整省煤器进、出口的过热度，防止了锅炉水冷 壁产生过高的热偏差，保证了机纽启动的安全性。 [关 键词]超超临界;660 MW机组;冷态启动;微油点火;蒸汽温度F 控制 [中固分类号] TM621; TK323 [文献标识码] B [文章编号] 1002-3364(2013)11-0172-02 [∞E 编号] 10. 3969/j. issn. 1002-3364. 2013.1 1. 172 Steam temperature control during the unit startup with tiny-oil ignition HUANG Weijun , PAN Ruiqiang , YU Xiaobo , SHI Baoquan Jiangsu Guohua Chenjiagang Power Generation Co. .Ltd. .Chenjiagang 224631.China Abstract: High steam temperature occurred during cold start of the ultra supercritical 660 MW u- nit in Jiangsu Guohua Chenjiagang Power Generation Company which was with tiny-oil ignition. On the basis of reason analysis ,the countermeasures were proposed ,namely putting the heater in to service at the beginning of the unit start-up to enhance the feedwater temperature and control the steam temperature ,which avoided the situation that the turbine was difficult to load up due to the excessive metal thermal stress after the unit was connected to the grid. By on-line monitoring and adjusting the superheat degree of the steam at inlet and outlet of the economizer , the over high thermal deviation on the water wall was prevented ,