基于伪随机系统辨识的电磁法仪器标定.pdfVIP

学兔兔 第35卷 第8期 仪 器 仪 表 学 报 VoL 35 NO．8 2014年8月 Chinese Journal of Scientific Instrument Aug．2014 基于伪随机系统辨识的电磁法仪器标定 刘立超，丁凯来，林 君，周逢道，刘长胜 (吉林大学仪器科学与电气工程学院 长春 130026) 摘 要：针对电磁法仪器标定需求，提出基于伪随机互相关辨识的标定方法。论述逆重复m伪随机编码序列的产生方法，从自 相关函数出发，推导逆重复m序列的频谱解析式。分析互相关法系统辨识进行仪器标定的原理，给出以逆重复m序列为标定 信号源时仪器和磁场传感器的标定方程，并讨论逆重复m序列的参数选取原则。最后，采用相关辨识分别对测量通道和感应 式磁场传感器进行标定测试。实测结果表明，标定结果幅度误差小于0．2％，相位误差小于0．5。；标定频率分辨率为0．244 Hz， 与传统的方波标定相比效率提高了75倍。该标定方法准确快速，频率分辨率高，可广泛应用于电子仪器标定。 关键词：标定；电磁法；相关辨识；逆重复m序列 中图分类号：TH763．1 文献标识码：A 国家标准学科分类代码：510．4010 Instrument calibration with electromagnetic method based on pseudorandom system identification Liu Lichao，Ding Kailai，Lin Jun，Zhou Fengdgo，Liu Changsheng (College of Instrumentation and Electrical Engineering，Jilin Unwenity，Changchun 130026，China) Abstract：Aiming at the demand of electromagnetic instrument calibration，a calibration method based on cross correlated identification using pseudorandom signal is proposed．The generation method of invert-repeated pseudo—random encoding m—sequence is discussed．The spectral analytic expression of the invert-repeated m—sequence is deduced starting from the self-correlation function．The principle of in— strument calibration based on cross correlated identification is analyzed；the calibration equations of the instrument and the magnetic field sensor are given when the invert—repeated m—sequence is used as the calibration signal source．Th e parameter selection principle of the invert—repeated m-sequence is discussed．Finally，calibration tests of the instrument and the magnetic field sensor were conducted re— spectively based on correlated identification．The calibrat