会展中心无支护部位及独立承台施工方法.docVIP

会展中心无支护部位及独立承台施工方法 会展中心无支护部位及独立承台施工方法提要：施工方法为分两层施工，第一层浇筑前，安装好钢结构预埋件，应在分次（段）浇筑的接口处水平施工缝下设一道不小于Φ12@200的水平向钢筋网 会展中心无支护部位及独立承台施工方法 对于无支护部位及独立承台施工，深度在2m以内的土方开挖采用1：1放坡；深度大于2m的土方开挖采用1：放坡。开挖后，即进行垫层的施工。 1独立承台施工顺序： 常年展厅独立承台施工→会议中心独立承台施工→综合展厅独立承台施工→广场区独立承台施工。 2独立承台施工工序： 独立承台基坑验收→垫层施工→钢筋绑扎→钢筋验收→支模→模板验收→混凝土浇筑→混凝土养护 3独立承台钢筋 独立承台垫层施工完毕后，养护一天，然后在垫层上划钢筋分格线，按照分格线绑扎承台钢筋。并注意绑扎柱插筋。 4独立承台模板 独立承台采用18厚木胶合板模板，100×100木方作为背棱，并用钢管进行支撑。 具体模板配置我们将专门编写方案及进行验算。 5独立承台混凝土浇筑 对于承台由于混凝土厚度有的很大，高度大于2米的承台需2次浇筑，每次浇筑高度不大于2米。 施工方法为分两层施工，第一层浇筑前，安装好钢结构预埋件，应在分次（段）浇筑的接口处水平施工缝下设一道不小于Φ12@200的水平向钢筋网，另预埋≥Φ12@500×500的竖向插筋，锚固长度和伸出段均为35d。然后浇筑混凝土1500mm高。使用插入式振捣棒应快插慢拔，插点要均匀排列，逐点移动，顺序进行，不得遗漏，做到均匀振实。第一层施工完毕后，养护达到设计要求强度后，安装钢柱。然后对已浇筑的混凝土面进行凿毛、清理，进行第二层混凝土施工。使用插入式振捣棒应快插慢拔，插点要均匀排列，逐点移动，顺序进行，不得遗漏，做到均匀振实。局部体积较大，厚度较厚的混凝土，应及时采取有效保温措施，防止混凝土内外温差引起裂缝。 待混凝土强度达到设计要求后，可进行土方回填，以便施工底板施工。 Measures for the routine management of moral education in Middle SchoolsMethod of conventional management of moral education in middle schoolFirst, the guiding ideology:School moral education is an organic whole of the whole education work, always adhere to the school adhere to the moral education, education for this product, and actively promote the quality education, the school building efficient curriculum system of moral education, moral education, improve the sense of attraction and appeal, enhance the moral education work for through and timeliness. Teach everyone, service education and management education, and school moral education work must be with family education and community education closely together, to form a concerted pattern, and strive to create a good atmosphere for education, and to promote the all-round development of students, to establish a scientific moral education full of vigor the For long-term mechanism.Two, the goal of moral education:To guide the students to form the correct world outlook, outlook on life, values, to cultivate students unity and mutual assistan