3年级下册15课《奇异的植物世界》教.pptVIP

Personal Protective Equipment (PPE) OTI 501 Trainer Course in Occupational Safety and Health Standards for General Industry Personal Protective Equipment (PPE) PPE should not be used as a substitute for: engineering controls work practices administrative controls Why Wear PPE? Barrier against workplace hazards prevent over exposure To prevent take home contamination prevent exposure to others outside of the work environment Standard Operating Procedures for PPE Evaluation of equipment needed to protect workers Employee training selection use maintenance limitations Personal Protective Equipment (PPE) OSHA incorporated the regulatory text of the General Industry Safety and Health Standards that have been identified as applicable to construction work into the Safety and Health Regulations for Construction (29 CFR Part 1926) on 6/30/93. Personal Protective Equipment (PPE) 1926.95 is the new PPE standard in construction. Protective Equipment; Final Rule was issued on April 6, 1994. 29 CFR 1910.132 General Requirements (b) Employee Owned Equipment (c) Design (d) Hazard Assessment (e) Defective and Damaged (f) Certification of Training 29 CFR 1910.132 Hazard Assessment Impact Penetration Compression (roll-over) Chemical Heat Harmful dust Light radiation 29 CFR 1910.132 Appendix A - References Appendix B - Non-Mandatory Compliance Guidelines for Hazard Assessment and Personal Protective Equipment Selection 29 CFR 1910.132 Training when PPE is necessary what PPE is necessary donning and doffing limitations care, maintenance, useful life, and disposal of PPE certification of training Personal Protective Equipment (PPE) Criteria for Selection of PPE 133 - Eye and face 135 - Head 136 - Foot 137 - Electrical 138 - Hand 29 CFR 1910.133 Eye and Face Protection ANSI Z87.1-1968 ANSI Z87.1-1989 * 29 CFR 1910.135 Head Protection ANSI Z89.1-1969 ANSI Z89.1-1986 * 29 CFR 1910.136 Foot Protection ANSI Z41.1-1967 ANSI Z41-1991 * ANSI American Nati