气焊工安全技术操作规程（四）.docVIP

气焊工安全技术操作规程（四） 气焊工安全技术操作规程（四）提要：乙炔发生器不得放置在电线的正下方，与氧气瓶不得同放一处，距易燃易爆物品和明火的距离不得少于10米，检验是否漏气 更多精品源自制度 气焊工安全技术操作规程（四） 1.施焊场地周围应清除易燃易爆物品，或进行覆盖隔离。 2.必须在易燃易爆气体或液体扩散区施焊时，应经有关部门检测许可后，方可进行。 3.氧气瓶、氧气表及焊割工具上，严禁沾染油脂。 4.乙炔发生器的零件和管路接头，不得采用紫铜制作。 5.乙炔发生器应每天换水，严禁在浮桶上放置物料，不准用手在浮桶上加压或摇动。 6.乙炔发生器不得放置在电线的正下方，与氧气瓶不得同放一处，距易燃易爆物品和明火的距离不得少于10米，检验是否漏气，要用肥皂水，严禁用明火。 7.点火时，焊枪口不准对人，正在燃烧的焊枪不得放在工件或地面上。带有乙炔和氧气时，不准施在金属容器内，以防气体逸出，发生燃烧事故。 8.严禁在带压的容器或管道上焊、割，带电设备应先切断电源。 9.在贮存过易燃易爆及有毒品的容器或管道上割、焊时，应先清除干净，并将所有气孔、口打开。 10.工作完毕，应将氧气瓶气阀关好，拧上安全罩。乙炔浮桶提出时，头部应避开浮桶上升方向，拔出后要卧放，禁止扣放在地上，检查操作场地，确认无着火危险，防准离开。 Measures for the routine management of moral education in Middle SchoolsMethod of conventional management of moral education in middle schoolFirst, the guiding ideology:School moral education is an organic whole of the whole education work, always adhere to the school adhere to the moral education, education for this product, and actively promote the quality education, the school building efficient curriculum system of moral education, moral education, improve the sense of attraction and appeal, enhance the moral education work for through and timeliness. Teach everyone, service education and management education, and school moral education work must be with family education and community education closely together, to form a concerted pattern, and strive to create a good atmosphere for education, and to promote the all-round development of students, to establish a scientific moral education full of vigor the For long-term mechanism.Two, the goal of moral education:To guide the students to form the correct world outlook, outlook on life, values, to cultivate students unity and mutual assistance, honest and trustworthy, law-abiding, good quality, hard work, set a good XX students ideological quality, psychological quality and image quality. The formation of excellent moral education curriculum system and management system, the construction of school. The society, family