细木制作工程施工方法.docVIP

细木制作工程施工方法 细木制作工程施工方法提要：基层弹线:根据图纸要求在清理完毕的基层上先弹好木制墙面的位置线，然后在木制墙面位置线中弹出饰面板分格线 其它精品 细木制作工程施工方法 1、施工工艺流程 基层处理 基层弹线 木龙骨安装 衬板安装 面板安装 面板清理 面板油漆 2、主要技术措施 1）基层处理：先将基层浮灰等进行清理，对于墙面平整度、垂直度不满足要求的进行修复。 2）基层弹线:根据图纸要求在清理完毕的基层上先弹好木制墙面的位置线，然后在木制墙面位置线中弹出饰面板分格线。 3）木龙骨架制作安装:根据饰面板分格线，在墙面上安装先预制的木龙骨网片，木龙骨网片采用开口榫连接，木龙骨可选用30ｍｍ×20ｍｍ的松木龙骨，间距不大于400ｍｍ，木龙骨经防火及防腐处理后，用圆钉与墙内木楔固定，检查木龙骨平整、垂直度，阴阳角方正度，木龙骨有无松动现象。 4）安装衬板:木龙骨上封9ｍｍ厚多层板，层板背面涂刷一遍涂料，接缝处用乳胶粘接，汽钉固定，气钉沿龙骨方向间距80－100ｍｍ，多层板拼口，上下口收边处及阴阳角处必须赶在龙骨上，检查衬板平整度、垂直度，阴阳角方正度，层板有无松动现象。 5）饰面板制作安装:按照设计木制墙面的分隔方式，进行预拼面板块，板块采用3ｍｍ厚的木层板制作，再检查合格后进行安装，安装采用乳胶与汽钉固定的方法。 3质量要求　　质量要求表 序号 检验项目 质量标准（mm） 检验方法 木制墙面 石材 墙面 柱面 1 表面平整 1 1 1 用2ｍ靠尺和楔形塞尺检查 2 立面垂直 2 2 2 用2托线板检查 3 阴阳角方正 - 3 - 用方尺和楔形塞尺检查或内外直角尺 4 接缝高低 用直尺和塞尺检查 5 接缝平直 - 3 2 拉5ｍ线（不足5ｍ拉通线），用尺量检查 其它精品 Measures for the routine management of moral education in Middle SchoolsMethod of conventional management of moral education in middle schoolFirst, the guiding ideology:School moral education is an organic whole of the whole education work, always adhere to the school adhere to the moral education, education for this product, and actively promote the quality education, the school building efficient curriculum system of moral education, moral education, improve the sense of attraction and appeal, enhance the moral education work for through and timeliness. Teach everyone, service education and management education, and school moral education work must be with family education and community education closely together, to form a concerted pattern, and strive to create a good atmosphere for education, and to promote the all-round development of students, to establish a scientific moral education full of vigor the For long-term mechanism.Two, the goal of moral education:To guide the students to form the correct world outlook, outlook on life, values, to cultivate students unity and mutual assistance, honest and trustworthy, law-abiding, good quality, hard work, s