冲压件外观检验规范.docVIP

冲压件外观检验规范(康柏标准)SPECIFICATION, COSMETIC, PRESS PRODUCTS.(COMPAQ STANDARD)1. 范围: SCOPE本规范对所有冲压件及小五金件(如螺丝,卯钉等)都适用.This specification defines the COSMETIC requirements for all press products and little metal products (such as Screw, rivet, etc).2. 参考文件: REFERENCE DOCUMENTS2.1 本规范参考下列文件制成:This specification is made by taking following reference documents.1.SPECIFICATION. COSMETIC. CPU/OPTION PRODUCTSDRAWING NO. 1061442.鸿海 SGC 106144 ‘CPU外观规范’FOXCONN SGC 106144 ‘specification, cosmetic, CPU/OPTION products’2.2 优先级: ORDER OF PRECEDENCE本规范若与零件图/规格相抵触, 则以零件图/规格为优先.本规范若与参考文件相抵触, 则以本规范为优先In the event of a conflict between this specification and piece part drawings, the piece part drawings will take precedence.In the event of a conflict between this specification and reference documents, this specification will take precedence.3. 检视方法: INSPECTION METHOD3.1 目视检测: 依下列规定检测.Visual inspection: Inspection shall be conducted as follows:3.1.1照明: 目视检测应依工厂常态照明(100±20呎烛光之冷白萤光照明)为 宜.Lighting: Visual inspection shall be conducted under normal shop lighting (100±20 foot candles cool white fluorescent illumination).3.1.2 位置: Position. 将待检测之对象置于检测者面前18至24吋(约手臂长)Place the product 18 to 24 inches (about an arm length) in front of the person performing the inspection. . 应以正对检测者及垂直于表面(即±45度角)两方向进行对象目视检测.The product shall be viewed in two positions, normal to the inspector and perpendicular to the surface (±45 degrees)3.2. 退货标准:Reject Criteria.3.2.1 直径小于0.01英寸之任何暇疵视为不可见.Imperfections less than 0.01 inch in diameter are considered invisible.3.2.2 如于目视检测发现外观上之可疑瑕疵,应参考适当等级之退货标准不应即冒然视为退货拒收.If suspected imperfections found while viewing the product, you need to refer to the appropriate surface class for the rejection criteria, not take it for granted that it is unacceptable.3.2.3 如可能,将缺陷加以分组归类以使对象成为合格. 例如:多而短小刮痕可能归类为一处磨损 成为可接受之对象. If possible, classify or group imperfections in order to make the product acceptable. For example: Multiple scratches could be classi