二保焊的准确焊接方法(国外英文资料).docVIP

二保焊的正确焊接方法CO2 gas shielded welding operation1 the arc(1) keep the dry elongation unchanged.(2) regressive arc method, which leads the arc of 10-20mm in front of the welding channel.(3) the head is worn thin and the joints are not melted.2 are-receive(1) keep the dry elongation unchanged.(2) collect arc at the edge of the molten pool.Arc and arc process, although it is easy to say that the arc of CO2 and the arc arc process are simple, it is necessary to master the standard operation technique if it meets certain quality requirements.Arc process: before the arc, keep a certain distance between the wire and the head of the wire, press the torch switch. In the arc, keep the dry stretch length stable. Because the temperature of the workpiece is low, the arc is not as long as manual welding, so it is necessary to use the retrograde arc method to make the welding channel full melt.Crater arc process: CO2 welding arc, should be kept dry, long and parked the burning point to molten pool edge arc, welding machine from complete back to burn, eliminate the ball, delay of protection of gas arc process.3 operation method(1) left welding (right and left) : high, width, little splash, convenient for observation of weld and welding process stability, gas shielded effect is good (non-ferrous metal must be by welding on the left), but more shallow penetration.(2) right hand welding (left, right) : big, small, splattered, easy to observe molten pool, melt deeply.(3) guns: zigzag.(4) flat Angle welding without swing or small swing.(5) vertical Angle welding and a triangle gun.(6) welder transition: stop on both sides of the molten pool and make a transition in the first 1/3 of the molten pool.(7) gun Angle: perpendicular to the weld, along the direction carry guns into 80-90 ° Angle.(8) test plate: interval 2.0-2.5 mm, starting arc point slightly less than arc point. Without a blunt edge, the deformation of 1 °.(9) to prevent defects:Prevent the Angle of the Angle from melting. No melt