皮革面料临盆流程(国外英文资料).docVIP

皮革面料生产流程 In order to improve the quality of our products, we are going to make sure that the production process of the factory and the various work of the factory are organized as follows, and we hope to give you a reference: BASE production process Cloth - sink {DMF, including soak} - pressure dry - drying - applied set {can adjust the thickness of the BASE} - big sink {DMF: 30%, water: 70%. The coagulation effect} - sink {consists of three small water tank. The three major sink is clean the BASE of sundry, the BASE of sundry clean} - drying {cooling by cooling tube around five} - setting machine - drying - winding The common BASE problem is as follows: The thickness of the {1} BASE will affect the feel of the handle, the BASE thickness will be slightly harder, the thinner will be slightly softer, and the BASE concentration will also affect the feel of the hand. {2} BASE also gets dirty. The water in the sink is not clean, or the bottom of the sink is black dot. Especially white. {3} BASE foaming and tension. Coagulation tank. It has to do with the wet formula, the bottom cloth {infiltrate not into the bottom brim} The width of {4} BASE is related to the contraction of the bottom cloth The low viscosity of {5} BASE and resin is also prone to blister. The manufacturing process of the half PU From type paper - coated} {PU surface color machine, oven, paint set {} is the middle material, belongs to the foam layer - oven {this oven makes the middle material foaming effect} - applied Taiwan {resin. The adhesive effect} - joint separation, drying oven, separated from the surface} {mold machine - winding The common problems of the average semi-pu are as follows: The color problem is related to the ingredients {2} has something to do with the surface for material. Workers improper operation in production, the clearance of the scraper coating machine and grain the wrong color also can appear 疘 problem. Because of the depth of the layer thickness will affect the color is di