外面粗拙度及其标注(国外英文资料).docVIP

表面粗糙度及其标注(国外英文资料) Surface roughness and its notes ? concept ? [text]? ????? Roughness is a parameter that measures the roughness of a parts surface, which reflects the microscopic geometry of the parts surface and must be measured using a magnifying glass. It is caused by the friction, extrusion, and the high frequency vibration of the tooling during the machining process. Surface roughness has a direct effect on the accuracy of the parts, abrasion resistance, sealing, corrosion resistance and parts. [text]? [text]? ????? Sample length: the length of the sample length is the length of the roughness geometry, which should have several peaks and the trough in the sample length. Five times the sampling length of the measurement is measured. ? To evaluate the parameters ? [text]? ????? Roughness is used to assess the general outline arithmetic mean deviation Ra, the maximum height of the contour, and the micro level of 10 high Rz. The smaller the number, the smoother the surface of the parts, the rougher the surface of the larger parts. The arithmetic mean deviation of Ra ????? Ra is the arithmetic mean of the absolute value of an absolute in the sample length, which can be expressed as: ????? See table below for numerical and surface features of surface roughness, methods and applications. ????? ????? As you can see from the figure above, the number of roughness parameters. These values should not be used when labeling. [text]? The maximum height of the outline The outline is not flat at ten o clock ? mark ? [text]? Codename and meaning ????? Roughness codes can be broken down into: symbols, roughness items, and values. ????? The commonly used annotated parameter is Ra, which the Ra can omit when annotated, Rz and Ry, and the corresponding symbols Rz and Ry are added before the roughness value. ? 2, label principle 1),? On the same pattern every note only one surface roughness codes, and should note in a visible contour lines, dimension lines, extension line or on the