27米钢屋架设计(国外英文资料).docVIP

27米钢屋架设计(国外英文资料) Design examples of steel structure courses -design data A single layer of single interindustrial building. The total length of the workshop is 120m, the column is 12m, and the span is 21m. There are two intermediate working bridge cranes in the workshop. Winter minimum temperature is 20 ℃ - in the region. The roof of the roof is 1.5 m by 12.0 m prestressing large roof panels, and the slope of the roof is 1:10. Upper berth 120mm thick foamed concrete insulation layer and three-felt 4 oil waterproof layer. Roof live load standard value of 0.6 kN / ㎡, snow load standard value of 0.5 kN / ㎡, heavy load standard value of 0.5 kN / ㎡. The roof is a trapezoid steel roof, and its hinges are hinged on steel concrete columns. Cylinder head section is 400mm by 400mm, the strength grade of concrete is C20. According to the temperature and load properties of the region, with Q235 steel - A - F, F = 215 kn / ㎡, its design strength electrode adopts the E43 type, manual welding. The components are made of steel plate and hot rolled steel, and the components and supporting connections are used by M20 common bolts. The computing span of the frame: Lo = 21000-2 x 150 = 20700mm, end height: h = 2000mm (axis), h = 2015mm (computing span). Two, structural form and arrangement The form and geometry of the frame are shown in figure 1. Figure 1 frame form and geometry size The roof support arrangement is shown in figure 2. The symbol: GWJ - (steel roof);SC - (upper string support) : XC - (lower string support) CC - (vertical support); GG - (rigid frame); LG - (flexible tie) Figure 2 supports the arrangement of the arrangement Load and internal calculation 1. Load calculation The load and snow load do not appear at the same time, so the calculation of the large live load is obtained. Permanent load standard value Water layer (three felt four oil with small stones) 0.35 kN / ㎡ 20 mm thick cement mortar screed-coat () 0.02 x 20 = 0.40 kN / ㎡ Thermal insulation layer (120 mm thi