工程测量思考题与习题(国外英文资料).docVIP

工程测量思考题与习题(国外英文资料) The first semester of the 2008-2009 academic year engineering measurement problem sets Chapter 1 introduction to 1. Noun explanation: perpendicular, level, earth, reference ellipsoid What are the functions of measuring work in various kinds of projects? What is the difference between measurement and measurement? What is earth level, absolute height and assumed elevation? What is the difference between the plane rectangular coordinate system in measurement and the representation of the coordinate system in mathematics? What are the two principles of measuring work and their function? What is the basic content of the measurement? What is the baseline for field measurements? Chapter ii level measurement The basic structure of the water level is made up of (A). (A) answer: the aim, the bracket and the base. Telescope, level, base. The aim, the base. The second reading of the station is (A), and the reading is (B). (A) answer: (2). (3) -. (B) answer:. (2). (3) -. The correct shafting of the level of the level of the level shall be satisfied with ____ (A). Answer: (A) (1) collimation axis tube shaft, shaft tube level coming ∥ vertical axis, vertical axis ∥ level axis. (2) the collimation axis ∥ pipe level axis, level axis vertical axis, vertical axis ∥ coming round level axis. (3) collimation axis ∥ tube shaft, shaft tube level ∥ vertical shaft axis, vertical shaft coming round level. The rulers top is the reference surface for reading the rulers reading, so when standing at the level, the ruler should be placed on the mark of the level. Isnt it? Why is that? An operation ____ (A) prior to reading the readings in the basic operation. (A) the answer: the instrument must be well placed, roughly flat, and the aim of the scale. Must be able to set up the instrument, aim at the scale, and work accurately. It must be done accurately and properly. A measurement of station level is , h 0. So... The rear end of the line is lower than the previous one. The rear