施工通病(国外英文资料).docVIP

施工通病(国外英文资料) One, the lightning proof ground does not meet the requirement 1, the phenomenon of (l) the defects such as cinder, welding, welding, biting and not full welds are found in the connection of the lower line, all pressure ring and the lightning belt. (2), the solder is not knocked off, the soldering area of the lightning belt is not painted with anti-rust paint. (3) the steel bar is replaced by a screw steel. (4) the main steel bar that is welded directly with the enemy shall be used as a lightning guard. 2, cause analysis, (1) the operator is not responsible, the welding technique is unskilled, most of them are the multi-faced welder in the electricians class, the operating skills of the opposite welding are poor. (2) the implementation of the national construction and acceptance specification GB50169 2 grounding device shall not be performed by the on-site construction manager. 3, the preventive measures (l), to strengthen the skills training of welders, lap it to the full in welding, smooth and uniform, especially the opposite welding and high overhead welding difficulty, such as welding training. (2) to improve the responsibility of the management and welder, to make up the faulty weld in time, and to knock down the slag and paint the anti-rust paint in time. (3), according to the GB50169 2 electrical equipment installation engineering and acceptance specification for construction of grounding device, lightning protection downlead of connection for lap welding, lap length is 6 times the diameter of the round steel, therefore, are not allowed to lap steel rebar instead of round steel. In addition, as the main reinforcing bar of the lower line is welded, it shall be filled in at the welding place by the regulation. Second, outdoor door is not in line with the requirement Phenomenon of l, (1) use thin wall copper tube instead of thick wall pipe. (2) it is not buried deep enough, and the position deviation is larger. (3), cooked in welding corner, on the w