普通钢屋架设计例(国外英文资料).docVIP

普通钢屋架设计例(国外英文资料) General steel roof design examples Design data: The span of a workshop is 30 meters, with a total length of 102 m, and the column is 6 m. There are two 30/5t intermediate working bridge cranes in the workshop. roof Using the 1.5 x 6 m prestressed reinforced concrete roof plate and roll roof, roof slope I = 1:10, the trapezoid roof is adopted. Roof support on the reinforced concrete column, column section 400 x 400 ㎜, concrete grade of C20. The standard value of roof living load is 0.7 kN/mm2 and the standard value of snow load is 0.5 kN/mm2. The steel of the roof is chosen Q235, the electrode is made of E43 and manual welding. The form and geometry of the roof are shown in figure 1. Figure 1 frame form and geometry size Design requirements: According to the design data, the frame support arrangement, roof rod, node design, and the frame construction drawings are made. Solution: 1, support layout The total length of the workshop is 102m, greater than 60 m, and set up the horizontal and horizontal horizontal support of the three lanes. Horizontal horizontal support is in the second column, in the first A column between the top chord plane rigid tie bar set, to ensure the stability of the first quarter, when installation in the first column bottom chord plane is set between the rigid tie bar pass gables wind load; In the same column of horizontal horizontal support, the vertical support of the two sides of the roof and the vertical support of the two sides of the building, respectively; The roof of the roof and the roof of the roof set up the long rigid frame. The support is shown in figure 2 below. The roof of the roof supports the arrangement of the arrangement Supporting the arrangement of the lower chord of the frame The roof of the roof supports 1-1 layout Vertical support 2-2 layout of roof span Figure 2 supports the arrangement of the arrangement Load calculation (the analysis is known by the permanent load effect) The roof load and snow load ar