桩基础(国外英文资料).docVIP

桩基础(国外英文资料) Select (fill in the blanks) : The three main mechanical properties of steel are (A). A. tensile strength, yield points, elongation The contents of the real abdominal axis are included (D). D. Strength, stiffness (length) The principle of steel structure design specification is a net cross section (B). The average stress meets the steel yield point The ideal axial compression component of the hinged joint, when the cross-sectional form is a two-axis symmetric cross, the component can occur (C) under the pressure of the axis. C. torsional buckling In order to improve the overall stability of the axial compression component, the area distribution (B) should be made in the form of section area under the condition of the section area of the component. Stay away from the shape as far as possible The area of the column sole of the spindle is largely dependent on (C). The level of strength of the base material In the design of the welded composite beam, the thickness of the abdominal plate should be (the thickness of C). The purpose of the stiffening rib in the welded section is (D). Improve the local stability of the beam The support of the beam should be set in (B). There is a fixed concentration of the upper and lower limb In the case of large fixed concentrated load on the beam, it should be applied to (B). B. set up the support stiffener The contents of the calculation of the actual bow-bending component shall be (D). D. strength, stiffness, bending moment and surface stability, local stability and long ratio The shear force should be taken (C) when calculating the material of a lattice pressure bending member. C. The actual shear design value of the component or the value of the shear force calculated by the formula The bending member of A single axisymmetric section is generally appropriate for bending moment (A). A The main consideration in the formula of integral stability in the plane of bending moments is the consideration of (A). The effect of the pl