柱子钢筋连接(国外英文资料).docVIP

柱子钢筋连接(国外英文资料) We aimed at the problem of how to connect the vertical stress bar pillar has carried on the discussion, this post viewed 3276 times, post has reached 103 as of Posting time 】 【. ???? Here is a brief summary of this post. ???? 1, column reinforcement is less than 12 mm, 14 mm generally adopt colligation lap, greater than 14 mm generally USES electric slag pressure welding is the most economic, from the consideration on the quality of reliability with straight thread sleeve. It is difficult to apply welding, and the technical level of the builders is higher. ???? If the rules are not prohibited, they may be carried out, and the key must be considered in terms of construction technology, construction quality and cost. ???? 3, from the construction cost into consideration, for more than 14 ㎜ reinforced using electroslag pressure welding save some, this technology is also widely used; ???? 4, can use one side welding, steel welding (welding) welding by one side or both sides meet the specification requirements, the good welding on lap in the structure, but also should avoid large structure parts. As long as you make sure that the soldering is not less than 10D, it will be ok to weld not less than 5D. When welding, use double-sided welding (the length of the lap is greater than 5d). In case of double welding, unilateral welding is not allowed. The thickness of the weld should not be less than 0.3 times the diameter of the main band, and the width of the weld should not be less than 0.8 times the diameter of the main reinforcement. ? (1) wuhuanhui, second floor? The 2008-12-30? 11:32:00 Can, but rarely used on the selection of construction technology, construction technology choice must consider that the construction quality, cost, schedule, and proficiency of the workers and technology level. So, generally USES overlapping column rebar is less than 12 mm, 14 mm electroslag pressure welding is the most commonly used economic, considering from the quality re