桥式起重机影响厂房造价的要素剖析(国外英文资料).docVIP

桥式起重机影响厂房造价的要素分析(国外英文资料) Thus increasing the cost of the factory and causing unnecessary waste. The 2.2 bridge machine itself is highly h3 and the hook rise limit is h5 The height h3 of the bridge and the rise of the hook rise is a relatively straightforward factor affecting the cost of the building. The plant height h1 is determined by the following formula: H1 is equal to h2 plus h3 plus h4 H2 = h5 + h6 Type: H1 -- the lower chord of the roof H2 - high level of bridge rail H3 - the bridges height (including the car) H4 - the gap between the bridge and the factory building H5 - the ultimate distance of the bridge hanger H6 - the maximum height of the product or equipment (the height of the hoisting line) The national standard gb/t - 14405 4.2.7 explicitly stipulated in the general bridge crane, bridge machine factory with the gap size between general should comply with the above clearance of not less than 100 mm, that is to say the h4 basic graphic is a fixed value. Due to the owner of the factory production of the bulk product or equipment determined by hook lifting height of the basic is calculated according to the actual size, so here is the h6 basic is fixed. H3 and h5 are usually determined by the design and process of the bridge, which is also the determining factor in the height of the factory building. 3 conclusion Abroad in recent years, lightweight, novel bridge machine gradually enter the Chinese market, at the same time, domestic bridge machine enterprises are machine research and development more reasonable and more economical bridge, the bridge machine products have excellent design, hook, hoisting height is high, the largest round down operation, etc, can be very direct factory to reduce the amount of steel beam, factory so as to save cost. This notably the coney crane equipment co., LTD., demag hoisting machinery co., LTD., shandong feng hui equipment technology co., LTD., is more outstanding, such as their machine product research and development