混泥土(国外英文资料).docVIP

混泥土(国外英文资料) What is the reinforcement rate? What is the effect of the reinforcement ratio on the bearing capacity of the beam? The ratio of the area of the cross-sectional area and the area of the component area is called the reinforcement ratio. Reinforcement ratio is most damage to the component, the experimental results show that with the change of the reinforcement ratio, the destruction of the component characteristics will change nature, damage from super steel reinforcement ratio is too large, reinforcement ratio is too small in less muscle damage What is the difference between the damaged characteristics of the beam and the beam? The damage of the short beam is brittle and the damage is sudden The plastic deformation and fracture precursors are not sudden and plastic properties Super steel beam before damage while also have a certain amount of deformation and fracture, but not as obvious as tension and compression damage, and when concrete crush, damage occurred suddenly, not make full use of the strength of the steel bar, damage with brittle nature 3. Why must meet in the double reinforced rectangular section bearing capacity calculation and x 2 or more or less a ` s condition? To prevent the mixing of soil in the affected area to be crushed before the tensile strength of the tensile steel. The design value of the compressive strength of the steel bar in the compression area can not be reached. Because when x 2 or less a ` s, compressive strain is small, the compression steel can not yield What is shear span? What effect does it have on the beams diagonal shear? The distance from the concentrated load to the pedestal is called the shearing span, the ratio of the shear span to the effective height h0 of the cross section of the beam is called the shear span ratio, which is a/h0 Shear span ratio is the main factor affecting the shear load capacity of the oblique section under concentrated load. When shear span changes over a certain range, the shear capacity