溷凝土缺点处理施工计划(国外英文资料).docVIP

溷凝土缺陷处理施工方案(国外英文资料) Guangzhou yuncheng media village in the southern district of concrete defect treatment construction scheme The formulation of the instructions In the construction phase of the main structure, some concrete and concrete diseases are presented, and the prevention and treatment of concrete quality of concrete and concrete is a key part of improving the quality of the project. In view of some of the present problems of concrete quality in the present project, this scheme is put forward, and the prevention measures and treatment methods are put forward. Common quality and prevention measures (1) the concrete honeycomb, 1, reasons: (1) the surface roughness and with dry concrete and water wet enough before pouring concrete, or template be not strict, cast, some concrete water loss too much contact with the template or slippery pulp, concrete and dry state, make the concrete surface to form many small pits. (2) the mixing time of concrete is short, the amount of water is not allowed, the concrete and the easy sex are poor, and the concrete is poured into the concrete after the concrete has been cast, and the mortar is more than gravel, forming a hive. (3) the concrete water is not layered and watered, and it is not properly made, causing the concrete to isolate and thus the beehive. (4) when the concrete is cast in poor quality or leakage, the honeycomb is caused. 2, preventive measures: (1) carefully before placing of concrete template firmly and examine whether the gap wall is good, the template should be clean with clear water wet, no water, and make the template crack expansion. (2) the concrete mixing time should be suitable, usually 1-2 minutes. (3) when concrete is poured over two meters, measures should be taken, such as using a series of tubes, tubes or vibrating tubes. (4) when the concrete is in the mold, the time must be mastered, usually about 20 to 30 seconds per hour. Proper vibrating time can be determine by the following phenomena: no