联合基础(国外英文资料).docVIP

联合基础(国外英文资料) (1) the calculation of the joint foundation The improvement of the eccentricity of the double-column combined foundation calculation: application in the design of double-column combined foundation, and does not take into account the result of the two pillars of the upper load inconsistent eccentric. So the base area is symmetrical. This kind of calculation method for the two pillars was close, such as the concept of deformation joints column has little impact on basis of calculation, but for the two pillars was the basis of it a little bit far, will have certain error. At this point, the designer is required to work out the value of the eccentricity and enter the value in the unique setting. Then the automatic generation option is reset, and the program can recompute the federated base based on the eccentric value of the input from the designer. The calculation of the double beam foundation is proposed: it is suggested that the two rib beams be placed directly on the double axis, and then the local raft will be arranged under the beam. (2) the calculation of the foundation of the masonry structure The masonry structure is usually built under the wall under the wall. Sometimes designers will find that JCCAD software has become an independent foundation in the form of conformational columns. This is mainly due to reading the PM constant 10. This method of loading doesnt spread the concentrated load on the structure to the surrounding wall. The designer can remove the concentrated load on the structure column in the load editor, and increase the load value on the surrounding wall in addition load. Or the designer can directly read the masonry load, because the masonry load automatically spread the concentrated load on the conformation to the surrounding wall. (3) how is the minimum reinforcement rate for shallow foundations calculated The shallow foundation such as the base of the wall under the wall, whether the minimum reinforcement ratio should be cons