16秋北交《汽车维修技术》在线作业一(国外英文资料).doc

16秋北交《汽车维修技术》在线作业一(国外英文资料) North hand in auto maintenance technology One, single topic (10 questions, total 25). The adjustment of the beam before the front wheel is achieved through adjustment (). Steering arm B. tie rod Turn to the ladder arm D. steering knuckle Correct answer: The radial tyre should be () when the secondary maintenance of the car is replaced. Cross transposition cycle Unilateral transposition D. it doesnt matter Correct answer: The widely used gear rack steering gear in the car belongs to (). A. reversible irreversible C. The limit is invertible D. all wrong Correct answer: The reason for the failure of the cylinder shock absorber is () The piston is too small between the cylinder and the cylinder The shock absorber seeps into the air C. The tear of the connection rod or the worn out of the rubber cushion D: none of the above Correct answer: The reason for the heavy rotation of power steering gear is (). Turn the oil pump down B. mechanical steering failure The pipe failure of the pump to the control valve D. control valve to power cylinder failure Correct answer: The safety steering mechanism used by santana is for () A. Buffer energy B. The network tube column changes form C. steel ball rolling separable Correct answer: In the electric control suspension frame, the elastic element is generally adopted (). Steel spring Spiral spring Air spring Twist spring Correct answer: The break of the steel spring is usually (). A. irregular The same severity C.Before than after serious Its worse than before Correct answer: For cars with a higher order, the suspension is often used (). Independent suspension B. non-independent suspension Balance suspension Dependent suspension Correct answer: The reason that the steering wheel automatically returns the wheel is (). A. there are stability moments B. reduces the arm C. the effect of gravity on the front of the car The effect of car traction Correct answer: North hand in auto maintenance technology (the total o