16秋北交《继电保护技术》在线作业一(国外英文资料).doc

16秋北交《继电保护技术》在线作业一(国外英文资料) North hand secondary protection technology online job 1 One, single topic (10 questions, total 30 minutes). The act of gas protection requires () A. when the inside of A transformer produces light gas, it should be instantaneous in the signal, and when A large amount of gas is produced, it should be moved to break the circuit breaker of the transformer When the gas is produced inside the transformer tank, the circuit breaker should be immediately used for signal and jumping C. when the gas is produced inside the transformer, the action should be made immediately Correct answer: In neutral ground system, the zero sequence current of the fault line at the beginning of the fault line is zero sequence voltage (). A. 90 ° in advance B. lag 90 ° C. 60 ° in advance D. lagging 60 ° Correct answer: When the current in the circuit exceeds the maximum load, there is a protective device called () that responds to the increase of the current. Voltage protection Differential protection C. overcurrent protection Overvoltage protection Correct answer: The power grid of 220 kv and above voltage level, the relay protection generally adopts the () principle. A. far back B. nearly a backup C. can be Correct answer: In three-phase current protection, the least protection is () A. instantaneous electrical current loss protection The speed of the current is broken Time limit for current protection Correct answer: Distance protection is the protection of the core components. An impedance relay Oscillating closed lock Starting element Correct answer: The neutral system is more reliable than the direct ground system. A.low B. high C. the same Not sure Correct answer: The first action is () after acceleration and acceleration. A. no choice, no choice No choice, no choice There is a choice, no choice Correct answer: The maximum measurement impedance that makes an impedance relay just happen is called a relay (). Integral impedance Measurement impedance Action impedan