修建给排水CAD近况题目及长大对策(国外英文资料).docVIP

建筑给排水CAD现状问题及发展对策(国外英文资料) The present problem of the design of water supply and drainage and the development countermeasures With the continuous development of computer application technology, especially in recent years, computer aided design (CAD) has been continuously penetration in the field of building water supply and drainage design, make our country in the aspect of building water supply and drainage had rapid development. However, there are some unique problems in the use, and this article talks a little about it. The present situation of the development of the design of the supply and drainage CAD Computer aided design and manufacturing (CADPCAM) was launched in the mid-1980s. When computer hardware was used on a workstation, the application of CAD was not well developed because of its large investment, and professional software was not well developed. In the rapidly since the 90 s, the development of the microcomputer processing capacity increasing, prices are lower, the popularity of the CAD application to become a reality, and thus provides a powerful drawing and design environment. Also gradually to increase at the same time, the design of the content, from only for general indoor water supply and drainage design development to indoor and outdoor water supply and drainage, hot water supply, fire protection, rain water, pumping station to the set of drawing and calculation for the integration of software packages. The development of the design of water and drainage CAD is carried out with the development of building CAD, and its professional software development is late. In early 1990, building water supply and drainage are limited to use CAD to draw schematic diagram, the lack of a complete gallery, only used in construction drawing design, in order to truly improve the design progress and drawing rate. Because of building water supply and drainage professional level the demand is higher, computer aided design software in the construction drawing by dr