地道凝土二衬施工(国外英文资料).docVIP

隧道凝土二衬施工(国外英文资料) Therefore, the pouring velocity should be symmetrical according to the design perfusion velocity. When mixed with concrete, the water can form a low quality layer and reduce the uniformity and integrity of the lining. Second, the concrete surface will be injected with the water, which will form a blister on the template. As a result, the water supply is applied to the drain hole on the block board. The concrete filling of the top part of the f. The method of upward injection is better than the concrete filling, and can also be squeezed by the filling. The main part of the concrete perfusion in the vault is not to produce any segregation, no gaps in the corners, and a complete filling of the plug. As a result, the concrete is continuously perfusion and removes the slurry and air from the opening of the block. G. In order to really fill the vault part, the study USES high liquid concrete, high liquid concrete is self-filling, and the material is difficult to isolate. In addition, usually the concrete produces a pulp that creates a small gap behind the arch. The high-liquid concrete has virtually no slurry, and the void caused by the slurry is not present. H. The upward filling mouth is generally appropriate for the 0.75 m on the concrete side. The farther away the concrete is from the concrete, the more difficult it is to flow, and the area near the vaulted vault is prone to void. Therefore, it is best to be near the concrete side of the perfusion. In order to reduce the air in the space, it can be installed in the concrete side. I. when filled was interrupted by the accident, change the concrete flow, can produce a hole and the thickness is insufficient, so each module standby power, spare concrete mixer, etc measures must be taken to ensure the continuous pouring concrete. Concrete tamping Vibrating USES the attached type of concrete vibrator and artificial plug-in vibrating rod, car process under springing line above, springing line, springing lin