场地排水坡度(国外英文资料).docVIP

场地排水坡度(国外英文资料) The slope of the drainage area In order to facilitate field drainage, ground slope should not be less than 0.3%, comprehensive consideration of other factors, ground slope should not be greater than 8%, all kinds of suitable slope surface drainage can be found in the listed in table 2-41: The drainage slope of the site is 2-41 Surface type drainage slope of type drainage slope The clay Sandy soil Lightly washed fine sand 0.3% 3% 10% wet loess 20 per cent in the area around the inflating earth building, and 5 per cent outside of 6m 2% in the 2.5 m area around the building The rainwater removal of the site is also an important part of vertical design. In fact, the high level of determination of the various parts of the site is partly a matter of the arrangement of rainwater in the field. Field rain ruled out there are two basic ways: the first is the surface of natural drainage way, this way is no any drainage facilities, using the terrain slope, and the characteristics of geological and meteorological to rule out the rain. The natural drainage pattern of the surface of the earth is generally applicable to smaller or smaller areas. Field rain ruled out the second basic way is to use an underground drainage, drainage in the area of large, flat, not suitable for using surface drainage, or site to health and the environment quality requirement is high, or the field most of the buildings from the roof using internal drainage, or field drainage system requirements adapted to urban rainwater pipeline system, adopts the pipeline rain ruled out way is more appropriate. In addition to the above two basic ways in the field of health and the environment quality requirement is low or investments limited, or base condition is limited, site of the rain out gutter drainage method may be adopted. The entire site scope of rainwater to eliminate system can adopt the above a certain way, also can be divided into some small partitions, mix the above ways. When using