大工12秋《钢结构》作业3答案(国外英文资料).docVIP

大工12秋《钢结构》作业3答案(国外英文资料) One, one, one, one, one, one, one, one, one, two, one, one, five? 1.?? A beam welded i-section section, materials for Q235, beam for uniformly distributed loads, and stiffener is supported has been set up in support, the web plate height and thickness of the beam is 900 mm and 12 mm respectively, if the stability of the web, is (). A. furnish longitudinal and horizontal stiffening ribs B. no need to be extra strong C. arrange the stiffening rib according to the construction requirement D ????????? Full marks: 6?? points 2.?? It is the main consideration of the plastic development coefficient in the integral stability check formula in the equation of bending moment. The effect of the plastic development on the bearing capacity The effect of the initial eccentricity C. residual stress D ????????? Full marks: 6?? points 3.?? When the wing of the beam and the abdominal plate are partially destabilized, the beam (). stiffness Intensity improvement Overall stability improved The bearing capacity will not be immediately lost ????????? Full marks: 6?? points 4.?? Rigid frame () in the building. To be able to do You can get pressure It can be curved D. can be compressed and curved ????????? Full marks: 6?? points 5.?? The pressure bar of the trapezoidal steel roof frame shall be required to meet the requirements of the selected section. A. such as stiffness B. strength such as C. such as stable D ????????? Full marks: 6?? points Two, the question (altogether? 13? The question of the tao? 52? 1.?? The commonly used roof form is: triangular roof, trapezoid roof, arched peace line roof. A. mistakes B. right ????????? Full marks: 4?? points 2.?? The section height of the composite steel beam shall be determined by the height of the building, the stiffness condition and the economic condition. A. mistakes B. right ????????? Full marks: 4?? points 3.?? The beams lateral bending stiffness, the stiffness of the torsion stiffness and the greater rigidity of t