电路板、电子元器件的焊接与装配(国外英文资料).docVIP

电路板、电子元器件的焊接与装配(国外英文资料) Welding and assembly of circuit boards and electronic components Welding tool: welding small electronic components with 20w internal combustion iron. Solder: solder wire with rosin in the middle. Welding methods: (1) the new electronic components and circuit boards are plated with tin and can be soldered directly. The old elements should be removed from surface oxidation, rust and dirt. (2) the heated electric soldering iron is placed at the junction of the pin and the circuit board and is 45 degrees in the plane. (3) heat the solder wire for 3-5 seconds and put the solder on the junction. When soldering tin is fully melted and fully combined, remove the soldering iron level solder wire. (4) the way to blow air is to quickly cool the spot. (5) the solder points are as small and strong as possible. (6) the welding time is as short as possible. Precautions for welding: (1) the soldering iron ground wire is connected to the grounding line of the power source to prevent the electric failure of the electric soldering iron. (2) use tweezers to hold the lead of the element when welding to prevent excessive temperature damage. (3) before the soldering tin is not solidified, the element should be shaken to prevent false welding. (4) when welding a variety of electrical components, the principle of first big and small. When welding electronic components and integrated circuit chips, the soldering iron shall be ground to the soldering iron, or the electric soldering iron will be cut off. Prevent the damage of the chip from the electric soldering voltage. Assessment elements: (1) to complete the welding and assembly of electronic circuits in the right way. (tools, solder preparation, welding procedure and method.) (2) the circuit function is correct by instrument test. (3) check the appearance, the electronic components are arranged in neat and smooth soldering. A.P CB welding process PCB welding process introduction The PCB welding process requires manu