绘制原理图和PCB图的过程中常遇到的一些问题(国外英文资料).docVIP

绘制原理图和PCB图的过程中常遇到的一些问题(国外英文资料) Select to display all hidden characters, okay? To reduce the PCB,? Then move the characters to the border. The DRC report network is divided into sections: ?? Does this network not connect, look at the report file, use the connection? COPPER lookup. Why cant the components of the network be fully adjusted, and why? A: the components of the network are defined in the library of the printed map. If the triode, its three pipe feet are defined in the principle diagram as B, C, and E. It is defined in the design library as 1, 2, and 3. Because they dont compare, they dont. The method that should be taken is to modify the component parts in the board design library to be consistent with the definition in the schematic diagram. Second, common problems Question 1: what is the component packaging, and what is the difference between it and the parts? Answer: (1) part packaging refers to the appearance and spot where the actual parts are welded to the circuit board. (2) the appearance of the parts packaged just parts and position of solder joint, the concept of pure components encapsulation is just a space, so different parts can share the same parts packaging; The same parts, on the other hand, also can have different packaging, such as RES2 represents the resistance, its packaging forms have AXAIL0.4, AXAIL0.3, AXAIL0.6, etc., so when taking the welding parts, should not only know the parts name also know parts of encapsulation. (3) the packaging of the parts may be specified when the circuit diagram is designed, or when the network table is introduced. When designing a circuit diagram, you can specify within the component properties dialog box, and you can also specify the component packaging when importing the network table. Question 2: what is the difference between a wire, a fly-wire, and a network? Answer: (1) wire is also called copper film line, referred to as wires, used to connect the solder joints, is the most important part of the p