粗粒料浸水变形分析方法的改进.pdfVIP

第 28 卷第 12 窃 毛101.28 No .12 岩石力学与工程学报 20自9 {r 12 fï Chlηese Journal 01Rock Mechanics and Engineering Dec.. 2009 粗粒料浸水变形分析方法的改进 先广军，殷宗泽 {到海大学岩土工程研究所，江苏南京 210(98) 摘W: 首先分析单线搓、双线法各自的住点和缺点，提出试验方E用单线法试验结果修正双结法试验结果，但计 算方噩仍用双线法计算的思路e 其次进行程粒料大三辑单线法和双线法湿化变形试验，对浸水变形特性进行研究， 发现单线法和双线法试验结果之陶的一些规律，并引用其他学者的试验结果进行验证，同样成立:同时，对该规 律的机制进行探讨z 基于该规律，提出一个改造的浸水变形分析方法.最后分别用改进方法和双钱法对试验结果 进行预溅，预测结果表明，改进方法计算结果和试验结果更加吻合。 美锺蔼z 土力学:租粒料z 湿化试验:浸水变形z 土石坝 中圈分类号I TU43 文黯篝识碍J A 立辈缅号I 1佣0-6915(2∞到12 - 2437 - 08 IMPROVEMENT OF涡ETTING DEFORM~τIONANALYSIS METHOD OF COARSE-GRAINED MATERIALS SHEN Guangjun. YIN Zongze (Institute ofGeotechnical Engineering. Hohai Universi.秽， Nanjíng , Jiangsu 210098 , China) Abstract: The advantages and disadvantages of single-line method and double-line method 岛r determining wetting de岛rmation of coarse-grained materials are analyzed. The ìdea of combining single-line method test with double-line method 如 solve we忧国g deformation problem is presented. The wetting de岛rmation tests of ωarse­ grained materials 缸.e c缸riεd out on the single-line method and double-line method by use of large triax.ial t臼t apparatus. Some laws of the test results between the single-line method and the double-line method are 岛und by studying 也e wetting deformatíon characteristics. The test results by other scholars also verify 也ese laws.τk mechanism of these laws is discussed. B硝d on these laws. an improvement analysis method for determining wett血g deformation is pres臼lted. Finally usìng improvement method and double-line method to predict the result of the