连铸结晶器电磁制动对铸坯中非金属夹杂物影响的研究.pdfVIP

Vol.28 No. 1 110 FOUNDR TECHNOLOG Jan.2007 1 1 1 1 2 2 2 2 战东平 , 张慧书 , 姜周华 , 龚 伟 , 宋景欣 , 程乃良 , 郭振和, 邹俊苏 ( 1. , 110004; 2., 210039) # : 对梅钢2 连铸机采用的FCMold( Flow Control Mold) 全幅二段电磁制动器对钢中非金属夹杂物的影响进行了研 结果表明, 采用电磁制动后,铸坯中心的夹杂物总个数少于未采用电磁制动的铸坯, 而前者边部的夹杂物个数则是后者的 2 2.06倍;铸坯中心和边部的夹杂物平均直径和平均面积均有所减小,铸坯中心的平均面积减小量达到8.44 m 钢中的夹杂 物主要为直径全部小于20 m 的Al O MnS 和CaS 夹杂物,还有少量含KNa 的夹杂物未采用电磁制动的铸坯中含 K 2 3 Na 夹杂物的数量明显多于采用电磁制动的铸坯采用电磁制动明显降低结晶器液面的波动幅度, 这有助于减少卷渣几率 电磁制动使用技术还有待于进一步优化研 : 炼钢;连铸; 电磁制动; 夹杂物; 板坯 TG249.7; T G245: : A : 2007) Inf luence of Electromagnet ic Brake in t he Cont inuous Cast ing on the Nonmetallic Inclusion of the Slab 1 1 1 1 ZHAN Dongping , ZHANG Huishu , JIANG Zhouhua , GONG Wei , 2 2 2 2 SONG Jingxin , CHENG Nailiang , GUO Zhenhe , ZOU Junsu 1. School of Materials and Metallurgy, Northeastern University, Shenyang 110004, China; 2. Bao steel Meishan Iron and Steel Cooperation, Nanjing 210039, China) Abstract: For No. 2 continuous caster in Meishan Steel plant the influence of Flow Control Mold Electromagnetic Brake ( EMBR) on the nonmetallic inclusionof the sla was studied. It was shown that with use of EMBR, the total amount of the nonmetallic inclusions inthe center of the sla is less than that of the sla producedwithout EMBR, while the inclusions inthe