非球面塑料透镜注射成型与注塑压缩成型工艺的对比分析.pdfVIP

第 29 卷第9 期 中国塑料 Vo l. 29.No. 9 2015 年 9 月 CHINA PLASTIα Sep..2015 非球面塑料透镜注射成型与注塑压缩成型工艺的对比分析 黄永程1 ，刘 ift. 滨1 势，邓利军2 (1.昆明理工大学机电工程学院，云南昆明 650500;2. 昆明学院自动控制与机械工程学院，云南昆明 650214) 摘 要:基于 Moldflow 对非球面塑料透镜注射成型与注塑压缩成型进行对比分析。结果表明，注塑压缩成型只需 要较小的注射压力和锁模力;压缩过程中使融化树脂受力均匀，成型制品产生较小的气穴和熔接痕，对外观质量影响 较小;在光学生能方面，注塑压缩成型的双折射率较小，满足光学镜片的使用性能，而注射成型Z 方向相移和Z 方向 迟滞变化范围较广，会产生明显的偏振现象，严重影响光学元件的成像效果。 关键词:非球面;注塑压缩成型;折射率E 偏振;相移;迟滞 中圄分类号: TQ320. 66+ 2 文献标识码:B 文章编号:1001-9278(2015)09-0067-06 Comparative Analysis of Injection Molding and Injection Compression Molding of Aspherical Plastic Lens HUANG Yongcheng 1 , LIU Hongbin1 势 ， DENG Lijun2 (1. Faculty of Mechanical and Electrical Engineering. Kunming University of Science and Technology.Kunming 650500.China; 2. College of Mechanical Engineering and Autornatic Control. Kunming University.Kunming 650214.China) Abstract: The injection-compressing and injection moldings of aspherical plastic lens were analyzed f and compared. The injection-compression molding required smaUer injection pressure and clamping force. The stress in the melt was uniform and smaUer cavitation and weld line , better appearance , and smaHer bi-refringence were obtained on the products. For the injection molding , the hysteresis and phase shift in Z direction were larger , which caused polarization in the products , resulting in worse quality of optical elements. Key words: aspheric surface; injection compressíon molding; refractive index; polarization; phase shift; hysteresis 的性能[阳3均] 。 前