《机械制造技术基础》习题（国外英文资料）.doc

《机械制造技术基础》习题（国外英文资料）Fundamentals of mechanical manufacturing technologyChapter 1 introductionWhat is the production process, process process and process discipline?What is a process, a station, a step, and a walking knife? Give examples.1-3 what is an installation? What is a folder? Whats the difference?1-4 single parts production, production, mass production, what are the technical characteristics?1-5 try for a lathe steam filature bar production line to determine production type, production condition is as follows: processing parts: horizontal lathe screw (length is 1617 mm and a diameter of 40 mm, screw accuracy level for 8, materials for Y40Mn); Annual output: 5,000 lathes; Spare rate: 5%; Reject rate: 0.5%.1-6 what is the location of the artifact? What is the grip of the artifact? Give examples.1-7 what is the underlocation of the artifact? What is the overorientation of the artifact? Give examples.The 1-8 examples illustrate the design criteria, process benchmarks, process benchmarks, location benchmarks, benchmark and assembly benchmarks.1-9 someone said: the workpiece in the fixture/clip, as long as there are 6 bearing point positioning, positioning is, all less than six positioning bearing point, it will be seen positioning, these all right? Why is that? Give examples.A 1-10 analysis of the positioning of the figure 1-8, and answers the following questions: (1) the degree of freedom that is restricted by each location. (2) to determine whether or not there is an under-positioned or overpositioning phenomenon, why?Figure 1-8 is a 1-10 diagramChapter ii cutting process and its control2-1 what is a cut using two or three elements? What do they have to do with the cutting layer parameters?2-2 determine how many basic angles are needed for the minimum geometry of a circular car knife? Try drawing these basic angles.2-3 try to describe the difference between the Angle of the tool and the Angle of work. Why is it that when the blade is cut, the quantity of feed ca