一个硬件工程师应当有的能力（国外英文资料）.doc

一个硬件工程师应该有的能力（国外英文资料） Think an electronic engineer/hardware engineer should have the following abilities: The analysis and design of analog/digital circuits. Textbooks should be, including the separation of components and operational signal amplification, filtering, waveform, regulated power supply, logical reduction, basic triggers, basic counters, register, and plastic pulse, ADC and DAC, phase-locked loop, etc. To be able to qualitative and quantitative analysis and design circuit functions and performance, such as stability, frequency characteristics, etc. These things need to be accumulated over time to be informed, and practice makes perfect. The principle and structure of computer. Todays electronic devices dont have to be on the computer, so make sure you understand the computer. To understand how the computer works, the software is how to run inside a computer (best oneself write a written procedures), to be familiar with the commonly used peripheral circuit and the interface of the computer system, and understand that the CPU and the peripheral circuit is how to coordinate work and so on. Its best to be familiar with McS-51, writing programs is not a problem, but its important to think about it, but make sure you do it. 3, PCB. The basic requirements are four layers, to understand the impact of PCB on EMI, ESD and to avoid it. It takes time to train the PCB to be beautiful and have no problem. 4, VHDL. Abroad, this is a requirement to master basic skills, which are also being popularized at home. It is mainly used to develop FPGA/CPLD devices and logical simulations, and IC design also USES VHDL as input. For the moment, if you dont ask yourself too much, you dont know. If time and energy permits, can learn the operating system, data structure, etc., of course you must first master C, C + + language, so that you can do in the future (software/hardware) system. But it must be good to have a power/electricity basis, which is the basis for learning other thi