初二物理学习方法（国外英文资料）.docVIP

初二物理学习方法（国外英文资料） The first two learning method: junior middle school physics experiment Adjust the balance beam balance Before the physical scale is weighed, the needle should be in the center of the scale. If the needle is on the left side of the ruler, the left end of the beam is adjusted to the left, or the right end of the beam is adjusted to the left. When the needle is to the right, the beam screw (whether the screw on the left or right) should be adjusted to the right, and the beam screw adjustment direction can be summarized as: Left, left, left, left, Right, right, right, right. The needle of a pallet balance is above the beam, so the adjustment direction of the beam screw is opposite to the physical balance. As long as the rules of the balance of physical scales are memorized, it is not confusing to think of a memory tray. (2) the use of sliding rheostat The sliding rheostat is divided into two layers, and the upper and lower resistance wires have two terminal bars, which should be used up and down to use one terminal post for the resistance. Shorthand for: One up, one for each. According to the connection, dont have to stick in the circuit diagram for connection to the physical connection direction of the slide rheostat, to choose short, avoid cross wiring way. (3) the entry method for connecting circuits Connection with parallel connection circuit of the circuit, can only connected parallel conductors in a first conductor, voltage meter also temporarily not access circuit, namely, first connect a series circuit, and then put the parallel conductors and volt access circuit, introduction to this method is called Im going to string it up. Doing so will make it difficult for beginners to make it easier. (4) one way to prevent misreading of data The scale of the physical scale is different. The upper scale of the cylinder and the thermometer is larger than the lower scale, while the spring and the hydrometer are the opposite. For a 0.6 ammeter, each tick is 0