模具公司出模流程（国外英文资料）.docVIP

模具公司出模流程（国外英文资料） Mould companys complete set of mould design process source: this site organize the author: whe time: 2007-12-05 click: 1560 - One. Design preparation Confirmation of the necessary drawings, the contents of the gold shi book, etc. Before formal gold design, the following drawings or documents are usually required: A picture of a product; A prototype of a gold design; To design and make contract books; (4) other The information is fully understood and the customers confirmation is not clear. Grasp the outline of the picture The final purpose of the gold design is determined by the quality diagram, which must be fully understood. The Japanese customer provides a collection of drawings which are drawn by the triangle method according to the JIS drawing, and usually consists of the following parts: Front, flat, profile, profile, detail, reference graph, note, general review, column mark, title bar, and other Note the following aspects in the view: Where the tolerance is stricter; The parts that have an effect on the gold structure; Part of an existing picture that cannot be understood; A special note in the notes Special materials and heat treatment requirements; The thickness of the wall is thinner (t 0.6 mm) The wall is thick and thick; There is no special requirement for the appearance The part of a three-dimensional surface; The designers, the date, the period, the price, etc The idea of a three-dimensional shape The sketch is drawn in two dimensions, and it is helpful to convert the view into a three-dimensional shape in the designers mind. Prepare the paper and pencil. First draw the outline of the outline of the product, then draw the sectional drawing of the parts according to the understanding of the part. These are very important to determine the classification of the subsets in the future. It would be better if conditions permit, use clay and other AIDS to help understand. Chinese mould video Review the title bar The title of the section of t