模具设计（国外英文资料）.docVIP

模具设计（国外英文资料）Chapter 1 description of the productThe structure of the plastic parts is simple, and the structure is simple. The material is polypropylene, the molding performance is general, the other has no special requirement.Chapter ii analysis of plastic partsChemical name: polypropylene (PP)Material analysis: plastic parts are made of polypropylene, which is plastic plastic. Look from the use of performance, the plastic has good rigidity, strong water resistance, heat resistance, dielectric properties have nothing to do with temperature and frequency, etc, is the ideal insulation materials; The plastic suction performance is small, the flow performance of the molten material is better, the forming is easy, but the shrinkage rate is large. In addition, the plastic molding is easy to produce the defects such as shrinkage cavity, dents, deformation, forming at low temperature, clear direction, solidification speed quickly, easy to produce internal stress. Therefore, it is necessary to control the molding temperature when forming, and the pouring system should be cooled slowly and not too fast.Plastic injection molding process parameters are determined: according to the structural characteristics of the plastic parts and the shaping performance, the forming process parameters of the polypropylene are obtained from the relevant manuals:Injection molding process parameters of plastic partsProcess parameter content of process parametersPreheating and drying temperature 80 ~ 90 ℃Molding time/s injection time 0 ~ 5Time 0.5 h assurance time 20 ~ 60Cylinder temperature / ℃The previous paragraph 180 ~ 200 cooldown time 15 ~ 50The total period of 200~ 220 is 35 ~ 115The rear section 160 ~ 170 screw RPM/(r/min) 30 ~ 60Nozzle temperature / ℃ of 170 ~ 190The reprocessing method is cold at room temperatureMold temperature / 20 ~ 60 ℃ temperature / 20 ~ 30 ℃Injection pressure/MPa 70 ~ 120 time/h 1 ~ 2The type and specification of the injection machine and the school kernelInjecti